go away spammer

Author Topic: servo speed  (Read 5978 times)

0 Members and 1 Guest are viewing this topic.

Offline ltmhallTopic starter

  • Jr. Member
  • **
  • Posts: 20
  • Helpful? 0
servo speed
« on: November 13, 2006, 01:49:12 PM »
Is there any way to increase the speed of two servo motors connected to a
Basic Stamp II? Or is the

PULSOUT 1, 850
PULSOUT2, 650

fastest they will turn.

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: servo speed
« Reply #1 on: November 13, 2006, 04:35:54 PM »
Servos have their own speed limits, typically expressed as 60 deg/ X seconds of time. The lower X is, the faster the servo can go. Different types of servos have different speed maximums.

To command the servo to go as fast as possible, just keep increasing/decreasing the pulse until it makes no speed difference.

The applied load also affects speed, so lower loads will equate to higher speeds.

If you require faster, you will have to buy a faster servo . . .

 


Get Your Ad Here

data_list