Hi, I am new to these forums,
Today my Axon2 arrived
It has been a little while since I have done any programming on an AVR based system. Previously I did some with the Atmega32 (SRS workshop robot) and Atmega128 (BDMicro Maveric). I have been meaning to do some more with the ATmega and I really liked the design of the new board as it is a lot easier to add things on to this board then I could do with the Maveric!
Currently I do most of my deveopment on Lynxmotion robots using the Basic Micro BAP28 microcontoller in Basic and some H8 assembly language.
So I decided to start working my way through the Getting started tutorial and cam up with a couple of questions and/or observations.
Setting up Software: Step 6, you mention you need to add the libraries in a certain order, but I dont think this order is matched in the shown image.
In steps 7-8: The program did not complile. The main problem is that it could not find a header file: servopwm.h. Looking through the header files, I tried servos.h and the program did compile after that.
I went on to the hardware page and installed the usb driver and the like. I then went on the bootload page and tried to download the bootloader and I get an error: /axon2/downloads/FBOOT17.EXE does not exist on this server.
I tried a couple of things like, maybe you were up to version 18 or 19 or 20, but same error, so finally found what I think the file is the right file at /axon/downloads/FBOOT17.EXE.
That is all for now, again I think this should be a lot of fun. Later I may have more questions about using the USB boot loader versus using AVRISP or AVRJTAGICE_MKIIā¦ But for now I will keep this simple.
Kurt