go away spammer

Author Topic: Aiko V2 New Designed with 3D printer  (Read 2645 times)

0 Members and 1 Guest are viewing this topic.

Offline Ai-botTopic starter

  • Full Member
  • ***
  • Posts: 94
  • Helpful? 0
Aiko V2 New Designed with 3D printer
« on: June 26, 2013, 02:21:51 PM »
Hi,

Took me many hours of non-sleep to finish the most natural movement robotic hand.
Designed and print from 3d printers.
It takes about 3 hours to print one finger, the hand took about 3 days to print.

The finger can do abduction, adduction, flex and extention.
Even the palm can move too.
Pinky and thumb movement is almost like human.
From posing peace sign, "OK sign" and even make a fist too.
The thumb can touch all fingers.
Weight about 500g.

Designed to work with 28 Flexinol Wire muscles (try with flexionl wire... work OK)
or
14 servo
I probably going to try both to see which is better.









« Last Edit: June 26, 2013, 02:40:04 PM by Ai-bot »

Offline jwatte

  • Supreme Robot
  • *****
  • Posts: 1,345
  • Helpful? 82
Re: Aiko V2 New Designed with 3D printer
« Reply #1 on: June 26, 2013, 03:26:16 PM »
That looks like a very well modeled hand. It seems like it's actually inspired by nature :-)

How are those joints attached? Is it bolts through the plastic? Is the plastic slippery enough to not need bearings or thrust washers?

Offline Ai-botTopic starter

  • Full Member
  • ***
  • Posts: 94
  • Helpful? 0
Re: Aiko V2 New Designed with 3D printer
« Reply #2 on: June 29, 2013, 04:01:16 PM »
The joint is joined by bolt with washer.
90 screws just for the hand.

Now I am fine tuning the pinky and the thumb.


Offline T0110100101101101K

  • Jr. Member
  • **
  • Posts: 34
  • Helpful? 1
    • Put your brochures to work for you!
Re: Aiko V2 New Designed with 3D printer
« Reply #3 on: August 04, 2013, 08:24:13 PM »

Weight about 500g.


It is pretty impressive how similar that is to the average human hand.  It is too bad that actuation is limited right now...strings or servos are definitely going to clutter up the design.  I am definitely no expert, but have you looked at playing with electroactive polymers?

A robot could do my job...

 


Get Your Ad Here