Society of Robots - Robot Forum

Software => Software => Topic started by: Razor Concepts on August 09, 2010, 10:28:58 AM

Title: Eagle3D - soldermask stop not working?
Post by: Razor Concepts on August 09, 2010, 10:28:58 AM
I was just wondering if somebody who has experience with Eagle3D could help me. Does Eagle3D not render the soldermark stop?

I had a bare PCB, no copper anywhere, just soldermask and an area of soldermark stop (tstop layer). Upon rendering, I only get a dark green board, there is no "pcb" material in the area where I designated the tstop.

Is this just how eagle3d works since usually it is not important?