Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: strat321 on January 23, 2013, 07:29:41 AM

Title: Axon II Smoking... need help
Post by: strat321 on January 23, 2013, 07:29:41 AM
I had everything on my axon set up correctly, including a servo on b5, a bat with a switch, and a vrbot on uart 2 and a 5v reg, all were connected correctly with ground wire on the outside pin.  However, when i turned it on, it started smoking and the robot in unresponsive.  The power light turns on.  Please help as this is very important for a project.
Thanks in advance
Title: Re: Axon II Smoking... need help
Post by: Admin on January 23, 2013, 11:14:30 PM
I've sent you an email.