can we use the same programmer for ATMega16 and ATMega8?The datasheet for my programmer says
Pin 1 AVR Mega 16 Pin 6 (MOSI)
Pin 2 AVR Mega 16 Pin 7 (MISO) and so on..
basically it seems like it's not intended for the AVR MEga 8 I'm using
i also tried 'Write All',
The unknown device error...msg appeared - I "ignore" d it
As Pony Prog contd writing (0%..15%..95%) the LED attached to the IC flashed
Finally when it had almost verified Pony Prog ends with "Write Failed"
**I was wondering what the flashing LED signifies the programmer is powered up correctly...the serial port is fine...the LED's connected correctly...and...? ***