Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: CameraGuy on June 14, 2012, 12:41:27 PM

Title: Information About Cameras
Post by: CameraGuy on June 14, 2012, 12:41:27 PM
     In the past I made my own board for the expansion bus of a 386. I used assembly language and DOS
and could control motors, read an adc, etc. For a new project I would like to install a camera and , using
assembly language, write a position sensing program. This time I might use a pentium and either DOS (if that is possible) or linux.

     Where would I find information about installing, controlling, and reading data from a camera using
assembly language?

                                       Thanks