Any of your guys who have worked with the sabertooth 2x25 by using Arduino? particularly PPM signals or PWM... I need to get my 2 pcs 24 volt 250 watt scooter motors going to move my tank..
will this code work with sabertooth 2x25?:
My setup:
S1 to pulsing pin 9 of arduino and 0 V of saber to the GND of the arduino
S2 to pulsing pin 10 of arduino and 0 V of saber to the GND of the arduino
Battery to B+ and B- ( 24 volt 7-ah SLA )
Motors to M1/A and M1/B and M2/A and M2/B
Code below:
#include <Servo.h>
Servo myservo;
void setup()
{
myservo.attach(9);
myservo.write(180); // set motor 1 to max full speed forward
}
void loop() {}
DIP setting:
non-lithium mode,microcontroller R/C input, independent mode with linear control
Your reply would be of great help,
tank