Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: mango1 on September 12, 2008, 09:30:34 PM
-
can someone please show me what this would look like on a breadboard?
http://downloads.solarbotics.net/misc/herbie1.gif
or even draw it on this picture with the help of paint?
http://ece-www.colorado.edu/~mathys/ecen2250/lab01/breadboard90.png
-
Tell you what, give it a try, and we will verify it for you.
I'm confident you can do it.
A trick would be to overlay the schematic onto the breadboard, and try to get it to look as similar as possible as you wire it up.
-
Try getting the
Robot Building for Beginners
by David Cook
The book is all about building a line following robot from scratch, based on a voltage comparator. It has all the pictures and information ull need.
-
I'd also reccomend Robot Building for Beginners book- great advice :D
Make sure that the Breadboard is wired up correctly for your device, otherwise the hard
ware will not perform to its highest standard.
All the best ;)