I just got done getting my USB Tiny put together and loaded the Axon 1.05 source, and used the blinking led example for the control.c:
void control(void)
{
int i;
PWM_Init_timer1_LED(
;
PWM_timer1_On_LED();
while (1)
{
for (i=110; i<255; i++)
{
PWM_timer1_Set_LED(i);
}
for (i=255; i> 110; i--)
{
PWM_timer1_Set_LED(i);
}
}
}
The green led never turns off...
In the Axon.c code the method calls should turn the green status led off after initialization, but it is never turning off. So I'm assuming it is never completing initialization, but I don't see anywhere in the initialization code that has a condition to wait.
How can I debug this thing? Is there anyway to get feedback using the isp?
I just loaded a new version of the code after removing the LED_on method call and after the code is done being written to the board (i.e. make program) the green status led just pops on and that's it no blinking or anything.
I'm out of ideas...
Well maybe not entirely...
I just tried loading the axon_test.hex from the site and it loads and verifies just fine, then the green status led turns on solid, but after a few seconds there is a blink. It isn't much, but at least there is some change!
Now I'm out of ideas again...
--
Evan
