Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: shiko250 on March 04, 2011, 09:22:29 AM
-
No matter how I program my Axon 640 (that I just received) my servo is always on as soon as I turn on the Axon, no matter what pin I plug it into. How do I fix this?
-
Hi,
Always on?
Do you mean always running?
If so, does it run regulary or irregulary?
-
Are you sure you are putting it on properly, i.e. ground (black) to the outside if you are using an Axon?
-
Sorry I was very non-descriptive of my problem.
I have a servo motor (Hitec HS-422) that I plug directly into my Axon 640 microcontroller (yes black wire to the outside). The motor deems to receiving direct voltage from the battery(no PWM) because it runs at a steady rate. It runs as if I had plugged the battery directly to the servo. I have been trying to figure this out for hours, turning on/off ports, changing code, and even putting in no code and still the same problem.
-
Figured it out... The Electrical Engineering department modified all the servos to be straight DC motors. So i was trying to run a DC pmotor off the port. I'm just lucky I didnt fry anything. Thanks anyways.