Mechanics and Construction > Mechanics and Construction
First attempt at a robotic arm! Suggestions for base?
Bciaren:
OK, so here's my base thus far!
Anyway, the problems I've been facing with this base is that it's all wobbly once I start attaching the arm! People suggest I install rollers, but I don't have any idea how to actually do that! I'm doing small scale here (1/8" thickness), any suggestions? Or better yet, a direction?
nanotechopolis_gr:
you should install rollers because otherwise your arm it will not has balance , check out the shematics ( i am not good at paint :P )
waltr:
Maybe a Lazy Susan bearing.
http://www.amazon.com/Susan-Bearings-Thick-200-lb-Capacity/dp/B0006LBVDI
Bciaren:
Wow! I am going to check that lazy susan bearing out! Thanks!
Fr0stAngel:
You could use a bigger servo horn... or perhaps a attach a support plate to the servo horn so it has more area under the base, and takes up force more evenly from the top
Navigation
[0] Message Index
[#] Next page
Go to full version