Society of Robots - Robot Forum

Software => Software => Topic started by: MarkBrown on May 15, 2009, 07:25:15 PM

Title: EAGLE & Header Pins
Post by: MarkBrown on May 15, 2009, 07:25:15 PM
I was inspecting my circuit after doing the routing and I noticed a problem with my header pins.  I am using 1x3 header pins, one set per pin per port.  When I line the pins up with the pins in my ATmega8, coping what was done in the $50 robot MCU, the green pads of the headers over lap.  I have attached a picture of what I mean.  Is there some secret I don't know about, or a particular header pin that works better?  Your help is appreciated as the only other thing I can think of at the moment is to use solder pads instead.

Thank you,
Title: Re: EAGLE & Header Pins
Post by: SmAsH on May 16, 2009, 01:55:43 AM
i use the "staggered" ones in the sparkfun library...
they work wonders... otherwise the other ones in the sparkfun are just as good...

and on a side note: does anybody know how to make the background black? its driving me crazy!
Title: Re: EAGLE & Header Pins
Post by: Admin on May 30, 2009, 02:03:52 PM
Oh, your using the wrong headers then. Look around for another, can't remember off the top of my head, though . . .