Electronics > Electronics
Atmega 16
(1/1)
darkjungle:
What would be the circuit connections in a line following robot,if i want to use atmega 16 instead of 8.
Should the pins xtal1 and xtal 2 be used or not.
Admin:
Hmmmm just check the datasheet pinout of the ATmega16.
The pin numbers and locations will be different, but the pin names will be the same.
For example, match AREF to AREF, B3 to B3, etc.
You will need to make slight modifications in code, as described for the ATmega168:
http://www.societyofrobots.com/step_by_step_atmega168_swapout.shtml
--- Quote ---Should the pins xtal1 and xtal 2 be used or not.
--- End quote ---
Only if you want to add a crystal to boost processing speed. Unless your bot does complex algorithms, I wouldnt bother with it.
Navigation
[0] Message Index
Go to full version