go away spammer

Author Topic: how do i solder this camera?  (Read 2107 times)

0 Members and 1 Guest are viewing this topic.

Offline BuddingContraptionistTopic starter

  • Jr. Member
  • **
  • Posts: 44
  • Helpful? 0
how do i solder this camera?
« on: October 21, 2008, 08:39:27 PM »
I found this camera for $10, and I notice that it isn't mounted on anything.  How would I wire that up?  They have other ones that are mounted on small breakout boards which look to contain a fair amount of circuitry.  Is this camera something i could connect power and i/o to and use out of the box?  Or is there more to it than that...

I'm really just amazed at the price

Offline izaktj

  • Robot Overlord
  • ****
  • Posts: 216
  • Helpful? 0
Re: how do i solder this camera?
« Reply #1 on: October 22, 2008, 01:15:02 AM »
Me too.

Offline pomprocker

  • Supreme Robot
  • *****
  • Posts: 1,431
  • Helpful? 16
  • Sorry miss, I was giving myself an oil-job.
    • Nerdcore - Programming, Electronics, Mechanics
Re: how do i solder this camera?
« Reply #2 on: October 22, 2008, 10:04:54 AM »
You'd have to put together some sort of image processing board i believe.

Offline hgordon

  • Expert Roboticist
  • Supreme Robot
  • *****
  • Posts: 373
  • Helpful? 7
    • Surveyor Robotics Journal
Re: how do i solder this camera?
« Reply #3 on: October 22, 2008, 11:02:36 AM »
That is an interesting camera because of the built-in JPEG, but to use it, you need a processor with an 8-bit parallel interface that runs at 20MHz, in addition to I2C for camera configuration.
Surveyor Corporation
  www.surveyor.com

 


Get Your Ad Here

data_list