Author Topic: AVRISP mk2  (Read 2710 times)

0 Members and 1 Guest are viewing this topic.

Offline GeirTopic starter

  • Jr. Member
  • **
  • Posts: 27
  • Helpful? 0
AVRISP mk2
« on: March 06, 2008, 04:22:25 PM »
Hi!

I just bought the AVRISP mk2 programmer and a ATmega168. First time i got the pins from the programmer wrong and it started blinking. But i reconnected every ting and it looks fine. But the led is always red i cant get avrstudio to connect to target. It connects to the programmer but not to Atmega. Can find the problem, im running on 3.3v, and i tryd just plugging the vdd and gnd from the programmer to 3.3 and look at the Vtarget and it reads 0.0v OK. Any one know whats wrong have i fried it?
$50 Robot schematic http://elektro.russemotto.com

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: AVRISP mk2
« Reply #1 on: March 11, 2008, 06:37:44 AM »
Did you reverse ground and power when you got the pins wrong? (but I dont think that will break it)

Its a solid red LED?

When it was blinking, what color was it? Orange?

It sounds like your wiring is not correct, or that you have an intermittent connection.

 


Get Your Ad Here

data_list