Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: adanvasco on October 11, 2011, 11:17:05 AM
-
Hello fellows.
I found this pair of emitter/receiver on eBay a few days ago: http://www.ebay.com/itm/1Pair-R-T-Ultrasonic-Transducer-Sensor-Source-Receiver-/300553606556 (http://www.ebay.com/itm/1Pair-R-T-Ultrasonic-Transducer-Sensor-Source-Receiver-/300553606556)
I just would like to know if by reading the seller's specs you can tell if these are good enough for a range finder.
Thanks in advance,
Adan.
-
Hi,
I just would like to know if by reading the seller's specs you can tell if these are good enough for a range finder.
They should be fine for the purpose :)
-
Thanks Soeren.
I thought so too, but wasn't really sure as I've never made anything like this before.
Thanks a lot.
-
Hi,
Looking forward to see your results :)
If you get into trouble with the direct (unreflected) signal desensitizing the receiver to the ping (reflected), you can make a "collar"/tube of something like foamed neoprene/rubber around each of them to minimize this.