Electronics > Electronics
Few questions in circuit
(1/1)
darkjungle:
The data sheet of atmega 8 says that Avcc should be connected to vcc through a low pass filter,if adc pins are used.Is it necessary?How?
Should the reset pin be grounded through a switch?
Admin:
I had the same question back in February:
http://www.societyofrobots.com/robotforum/index.php?topic=606.0
--- Quote ---Should the reset pin be grounded through a switch?
--- End quote ---
No, you need that pin for the programmer.
This is what I did:
http://www.societyofrobots.com/images/sbs_avr_schematic.png
Navigation
[0] Message Index
Go to full version