Electronics > Electronics
H-Bridge with Two 2-way Motor control
(1/1)
Icewind007:
I am using the SN754410 QUADRUPLE HALF-H DRIVER. It says it can be used with two 2 directional motors. I am not very familiar with how to work with these but I managed to use an entire one of these H-bridges to get one motor going two directions. Could I get any tips or schematics on how to properly get this one h-bridge to run two motors in two directions? The specs are at this website.
http://info.hobbyengineering.com/specs/SN754410.pdf
JonHylands:
Check out the schematic on my Seeker 2 page:
http://www.huv.com/miniSumo/seeker2/Schematic.gif
- Jon
ed1380:
--- Quote from: JonHylands on May 03, 2007, 10:00:16 PM ---Check out the schematic on my Seeker 2 page:
http://www.huv.com/miniSumo/seeker2/Schematic.gif
- Jon
--- End quote ---
that looks like a mixture of these 2 http://www.allegromicro.com/en/Products/Part_Numbers/2981/index.asp and http://www.allegromicro.com/en/Products/Part_Numbers/2559/index.asp
according to your link "K" on my second link could be "Rc2" and "Rc3"
JonHylands:
Well, its not, its a single SN754410, which is why I pointed it out...
- Jon
Navigation
[0] Message Index
Go to full version