go away spammer

Author Topic: AVRISP 2 stays red when connected to target  (Read 2381 times)

0 Members and 1 Guest are viewing this topic.

Offline harisankarsaTopic starter

  • Jr. Member
  • **
  • Posts: 23
  • Helpful? 0
AVRISP 2 stays red when connected to target
« on: May 05, 2008, 12:54:16 PM »
My AVRISP 2 stays red when connected to target...It blinks orange if i interchange a few wires,but otherwise its not working..I had to upgrade my firmware as my programmer was made in Nov 2007..After i upgraded, it worked two or three times,but after that its is not working at all.I have tried manual firmware upgrade, but it hasnt helped me.

Offline pomprocker

  • Supreme Robot
  • *****
  • Posts: 1,431
  • Helpful? 16
  • Sorry miss, I was giving myself an oil-job.
    • Nerdcore - Programming, Electronics, Mechanics
Re: AVRISP 2 stays red when connected to target
« Reply #1 on: May 06, 2008, 12:03:13 PM »
Double check the programmer board that your IC socket is on with a multimeter.

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: AVRISP 2 stays red when connected to target
« Reply #2 on: May 17, 2008, 05:19:53 PM »
How are you powering it?

Double check your wiring, sounds like you made a mistake . . .

 


Get Your Ad Here