Society of Robots - Robot Forum

Mechanics and Construction => Mechanics and Construction => Topic started by: bobthefirst1 on September 16, 2012, 10:19:47 AM

Title: How to connect this motor
Post by: bobthefirst1 on September 16, 2012, 10:19:47 AM

I need ideas on how to attach this motor to spin a pipe. Look at the picture
(http://motorthign.png)

Title: Re: How to connect this motor
Post by: Billy on September 17, 2012, 02:18:58 PM

use epoxy to glue the motor shaft into the hole on the pipe.

A better answer will require a better question. Look at your question.

Title: Re: How to connect this motor
Post by: misrobot on October 12, 2012, 02:37:41 PM

How about using a rubber sleeve on the motor shaft to drive yout pipe in either direction

you can use  a motor base fulcrum  with a spring to keep constant drive pressure