Society of Robots - Robot Forum
Software => Software => Topic started by: ATRmaker on September 29, 2011, 09:34:20 AM
-
Hi
I new at this , but i can't get any communication between by xbee devices
i'm am using ladyada tutorial
The problem is this :
Action required. Unable to communicate with modem. verify com port with action below
XBEE:
press and release reset switch.
dialog box should close within 10 seconds
THANKS
FOR ANY HELP
-
Do you have the right firmware loaded? One of them has to have the controller firmware, and the other the slave. I don't recall the right terms off the top of my head but ...
Joe
-
Which XBees? There are several hardware modules and protocols.
Give the Series # and the Firmware Version # as reported by the Query command in X-CTU.
-
Xbee series 1 ,
when i get to test and query it says
Unable to communicate with modem.
due to this i can't get the firmware version
http://www.ladyada.net/make/xbee/configure.html (http://www.ladyada.net/make/xbee/configure.html)
-
I figured out the problem, there was an error with the adapter
Thanks for all your help
-
Thread is useless without what adapter and what the problem with adapter/solution was. :)