go away spammer

Author Topic: Need help with servos  (Read 2505 times)

0 Members and 1 Guest are viewing this topic.

Offline TVATopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
Need help with servos
« on: October 08, 2008, 01:43:14 AM »
I have 2 cheap servos that i got from an old RC toy. Problem is that they only have two wires. That means that they are just simple DC motors geared down and unmodified to run 360. I want to use them to drive the wheels of the 50$ robot. What do i have to do to use them?

Offline ArcMan

  • Supreme Robot
  • *****
  • Posts: 519
  • Helpful? 4
  • Mmmm... Plasma
Re: Need help with servos
« Reply #1 on: October 08, 2008, 06:32:29 PM »
You'll have to drive them with a motor driver then - like the L293D chip.  Check out this site and the internet to learn about them.

Offline szhang

  • Robot Overlord
  • ****
  • Posts: 140
  • Helpful? 1
    • szhang.net
Re: Need help with servos
« Reply #2 on: October 08, 2008, 11:02:33 PM »
you also need to supply a PWM control signal to vary the speed.

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: Need help with servos
« Reply #3 on: October 10, 2008, 05:14:52 AM »
This question has been asked a billion times. As such, I added it to the FAQ:
http://www.societyofrobots.com/robot_faq.shtml#servo_vs_motor

 


Get Your Ad Here

data_list