Don't ad-block us - support your favorite websites. We have safe, unobstrusive, robotics related ads that you actually want to see - see here for more.
0 Members and 1 Guest are viewing this topic.
check for both pd0 and pd1 they whoudl workthe admin mentions it in his tutorial,,IRRELEVANT TO THE TOPIC...may i kn ur age plzz
may i kn ur age plzz
connect the right wires to the pin...there is wire named signal.....one is +ve 6v and one is ground connect them in their righ tplaces...IRRELEVANT TO THE TOPICiam 20... and single lol..
Quote from: superchiku on March 09, 2009, 01:41:21 PMmay i kn ur age plzz worst pickup line ever
are u sure ur wiring is correct ...i mean ur mcu and all are getting power correctly ...or is ur servo getting power...wat kinda servo are u using...did u modify it right... ?IRRELEVANT TO THE TOPIC>>sumtimes u feel lonely ...techies got very few friends...anddont address "young man" etc etc etc ...makes me feel as if u are very old...
if the servo is getting power....then i guess there is some fault in ur modding..........coz if there would have been any prob in theadin's code then other ppl would have noticed it by now...and also he has clearly mentioned use pind0 or pind1 and neither of them is working...so i guess the fault is in ur side ..why don u get umultimeter and check out the outputif the pin d0 and d1 ..if they are giving voltage...then ull be sure that the fault is in th servo..IRRELEVANT TO THE TOPICrighly said....but wth...this is life and it goes on...but be happy alwayz...HAKUNA MATATA
Did u follow the ADMIN's tutorial properly..try to use an unmodified servo...in place of this one and see if it works...
see the previous reply .... yes unmodified means that ur using the servo with factory settings...directly out of the pacakaging...not opening it up or cutting the gears...
the pin output not the power for the servo...wat is the output from the pin .. ...
5) Next we need to center the servo. Do this by plugging it in to your controller and send the signal required for it to go to 0 degrees. You should probably see the gears rotating without stopping. Now rotate the pot head (no, not that type of pot head) so that the gears stop rotating. It will probably be very sensitive so take your time. It is very important for this to be perfect. Get some superglue and glue the pot head to make sure it remains in place.