Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: frodo on January 17, 2009, 07:23:00 PM
-
hi, has anyone used the Futaba S148 servo? if anyone has, is it the same to modify as the hitec HS-311 using admins instructions?
-
All servos run on the same principle, so you will be able to modify it without a problem.
-
ok thanks.
-
Some of the really small micro servos aren't modifiable, at least not easily. Standard size servos are all modifiable.
-
just for those interested, the Hitec HS322-HD is one of the easiest servos to mod to 360 degrees. Just center the servo, remove the gear case, cut the notch on the drive gear, cut the exposed knob off from the pot and glue the cut knob. your done. web has good pics of it