Society of Robots - Robot Forum
General Misc => Misc => Topic started by: cooldog on December 04, 2009, 09:56:07 AM
-
so i got a eagle board done. and i want to print it. it is two sided. how do u guys print it so that only the bottom layer is printed or only the top?
i tried changing viable layers but the boards came out different sizes.
-
Noway, unless you change the scale factor there is no way that gonna happen,
check the frame side of the two boards, if it's the same
-
Here's a tutorial I found for printing out Eagle boards, http://www.cnczone.com/forums/showthread.php?t=33374 (http://www.cnczone.com/forums/showthread.php?t=33374) a bit over complicated but it works just fine. I printed out two layers of a circuit following this tutorial and it came out the same size.
-
thanks :) ill give it a try
-
http://www.societyofrobots.com/electronics_Eagle_export_tutorial.shtml (http://www.societyofrobots.com/electronics_Eagle_export_tutorial.shtml)
Each file represents a different part of the board. Just look up which ones represent the upper layer.
Or if you meant printing with a paper printer, just turn off the layers you don't want to see (in the top drop down menu).