hey all, ive been at this problem for a while now and just cant seem to figure it out so i figured id turn you you guys.
ive been following the tutorial
http://www.societyofrobots.com/electronics_Eagle3D_tutorial.shtml and have done everything it says to do, and everything is fine up until the point where the rendered image is supposed to pop up.
instead of an image popping up, i just see a few thousand lines of code pop up...
so first, i open my eagle file in eagle 5.0.0 light, type in "run" in the bar up the top and press enter.
i get the error "no board outline found. generated pov-ray file may contain errors" i click "ok".
i get the menu and set up the viewing angle etc... it says the file was created successfully so i move on to open pov-ray 3.6 for windows. i click "open file" and select my pov-ray file to open. it opens.
i open the povray.ini and edit it with "Library_Path="C:\Program Files\EAGLE-4.16r2\Eagle3D\povray""
then i click the "ini" button and it comes up with the "I/O restriction activated" error, i click ok and continue.
then when the image is supposed to pop up all that happens is a bunch of code pops up... (see image)
does anyone else get this problem or has had this problem?
its quite frustrating...
thanks for your time guys, i really appreciate it.