Author Topic: brush water after soldering?  (Read 2020 times)

0 Members and 1 Guest are viewing this topic.

Offline Joesavage1Topic starter

  • Robot Overlord
  • ****
  • Posts: 268
  • Helpful? 0
    • Dev-HQ - Learn C++, Visual Basic, HTML and More!
brush water after soldering?
« on: February 03, 2009, 01:28:54 AM »
don't you brush water over the solder after its dried or something (if its water soluble) other wise use white spirit or alcohol depending on your solder.

Joe
Logged

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: brush water after soldering?
« Reply #1 on: February 15, 2009, 05:00:45 AM »
Only if you used acid based flux. I use 'no clean' flux cause I'm lazy :P
Logged

Offline Joesavage1Topic starter

  • Robot Overlord
  • ****
  • Posts: 268
  • Helpful? 0
    • Dev-HQ - Learn C++, Visual Basic, HTML and More!
Re: brush water after soldering?
« Reply #2 on: February 15, 2009, 06:42:24 AM »
Oh.. Ok Thanks

(PS: why u start new thread?)

Joe
Logged

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: brush water after soldering?
« Reply #3 on: February 15, 2009, 07:16:20 AM »
You were thread-jacking, asking a question unrelated to the thread you posted your question in :P
Logged

Offline Joesavage1Topic starter

  • Robot Overlord
  • ****
  • Posts: 268
  • Helpful? 0
    • Dev-HQ - Learn C++, Visual Basic, HTML and More!
Re: brush water after soldering?
« Reply #4 on: February 15, 2009, 08:29:54 AM »
oh ok; sorry i didnt realise.


Joe
Logged