Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: mystyleonfire on June 19, 2008, 10:45:14 AM

Title: Help me design Line follower using ATMega32 Please
Post by: mystyleonfire on June 19, 2008, 10:45:14 AM
Hi folks,
 Im Karthik from India. I am a beginer to line follower. And I would like to have some guidance about the circuit. Please help.
Title: Re: Help me design Line follower using ATMega32 Please
Post by: Admin on June 21, 2008, 05:19:32 PM
Seen this yet?

http://www.societyofrobots.com/step_by_step_robot.shtml
Title: Re: Help me design Line follower using ATMega32 Please
Post by: mystyleonfire on June 21, 2008, 07:21:44 PM
Yes, I have seen iit. But i need to design using ATMega32 MC.
Title: Re: Help me design Line follower using ATMega32 Please
Post by: Admin on June 21, 2008, 07:45:11 PM
Why the mega32?

Read the bottom of this page:
http://www.societyofrobots.com/step_by_step_atmega168_swapout.shtml

Then read the rest of the page . . .
Title: Re: Help me design Line follower using ATMega32 Please
Post by: mystyleonfire on June 21, 2008, 07:50:48 PM
Oh, Thats cool. So, only the pin out are different. Means, If VCC and Port 1 for ATMega8 is 1st and the 19th pin(for example), then if the VCC and Port A for ATMega 32 are 20th and 16th pin. are they same? if i do the connections according to it, will it work out?im jst a beginer.
Title: Re: Help me design Line follower using ATMega32 Please
Post by: Admin on June 21, 2008, 07:59:32 PM
Yeap!
Title: Re: Help me design Line follower using ATMega32 Please
Post by: mystyleonfire on June 21, 2008, 08:02:47 PM
ok. Thanks a lot. And can u guide me thru the processes? PLease...
Title: Re: Help me design Line follower using ATMega32 Please
Post by: Admin on June 21, 2008, 08:32:16 PM
Just post what you think the schematic will be, and we can verify it for you before you wire it up.

(its very very similar to the $50 Robot schematic, so after a little thought it should make sense to you)
Title: Re: Help me design Line follower using ATMega32 Please
Post by: mystyleonfire on June 21, 2008, 08:34:00 PM
OK.... Thank u a lott. :)