Buy an Axon, Axon II, or Axon Mote and build a great robot, while helping to support SoR.
0 Members and 1 Guest are viewing this topic.
while (1) { PORTD.7 = 1; delay_us(200); delay_us(200); delay_us(200); delay_us(200); delay_us(100); PORTD.7 = 0; delay_ms(19); delay_us(100);}
Your delay is .9ms .
should the micro and the servo share the same ground?
So what would happen if your servo requires 400mA,
In short, if you stall a motor, you reduce the lifetime until its been 'trashed' (destroyed, hence you throw it away in the trash).
Quote from: Admin on February 11, 2008, 07:55:45 PMIn short, if you stall a motor, you reduce the lifetime until its been 'trashed' (destroyed, hence you throw it away in the trash).But still!!! It has a nice small ESC on it!!!You probably be a able to drive a small hobby - toy motor with the dead servo's electronics!!! (forward / backward)And as mentioned before... servos can handle a lot abuse... but just don't over do it...Also keep the gear box and try to find a motor fitting to replace the old-burned motor... This will reduce the whole maintenance cost of your project-robot
i want it to take longer, so should i change the PWM gradually?