Society of Robots - Robot Forum
Mechanics and Construction => Mechanics and Construction => Topic started by: apluscw on April 29, 2013, 06:41:41 PM
-
Any suggestions where I might find gears that fit a 4mm diameter shaft with D-shaped key feature?
THX!
:)
-
This link makes all kinds of gears.
http://www.rushgears.com/?referrer=GoogleGeneralGears&gclid=CNaT-p3a97YCFU6f4AodmQIAJQ (http://www.rushgears.com/?referrer=GoogleGeneralGears&gclid=CNaT-p3a97YCFU6f4AodmQIAJQ)
These would work, just tighten the set screw on to the flat side of the D on your output shaft.
http://www.pololu.com/catalog/product/1081 (http://www.pololu.com/catalog/product/1081)
If possible find one that works here, as they help sponsor this site.
http://www.servocity.com/html/gears.html (http://www.servocity.com/html/gears.html)
Hope that helped.
-
THX! Wish robot parts weren't SO expensive. :(
-
I know what you mean....