Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: garriwilson on August 03, 2007, 08:39:09 PM
-
Ok I made the photoresistors and used 1.62k ohm resistors. I soldered the wires to the photoresistor and soldered those to my perf board. But there is a problem. Every time I move my perf board, the wires keep ripping off. Any other ways?
-
Hi,
Zig-zag the wires a through a couple of holes before meeting with the solder points for strain relief.
-
Cooooooooooooooooool, thanks. That's a great way. Thanks again.