Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: mihies on December 09, 2008, 01:10:40 PM
-
Hi guys,
Where would I find a cheap crimpers for these connectors (preferably in Europe):
http://www.hochien.com/2550.htm (http://www.hochien.com/2550.htm)
Are crimpers discussed in these forums (i.e. for Molex connectors) suitable?
-
these answers are allover the forum...but heres the scoop:
use pin crimpers that can handle that gauge and your set. You can find cheap crimpers everywhere, approx: $10.00USD
-
these answers are allover the forum...but heres the scoop:
use pin crimpers that can handle that gauge and your set. You can find cheap crimpers everywhere, approx: $10.00USD
I just wanted to know whether there are any specific issues with those connectors. I know there were a lot messages about crimpers.
Thanks,
Miha
-
I haven't used those particularly pins/headers . . .
potentially helpful:
http://www.societyofrobots.com/electronics_wire_connector.shtml