Society of Robots - Robot Forum
Mechanics and Construction => Mechanics and Construction => Topic started by: photray94 on May 04, 2008, 02:18:35 PM
-
Link;
Here's a link to the page I'm questioning (it's the $50 robot tutorial): http://www.societyofrobots.com/step_by_step_robot_step1.shtml (http://www.societyofrobots.com/step_by_step_robot_step1.shtml)
Question;
After opening the page, scroll down to the Tools/Misc List. This is the only list without explicit guidance. Element one and two of the list, "Wires," and "Screws," I would like to know what kind of "Wires," we're talking about, and what size/quantity of "Screws," and "Wires," I will need for the project.
Thank you in advance,
photray94
-
I would recommend jumper wire for the circuit board work, and 22awg wire for the photosensors.
and for screws, you don't need any as the servos come with mounting screws.
-
Just curious, is this recommendation built off of experience building this robot and/or other robots, or just an educated guess in general?
Thanks,
photray94
-
in terms of wire, its preferance as long as it meets the current requirements. I wouldnt want to use stranded wire on a board though... especially on a bread board. I ran out of jumpers and had to finish a project with hook-up wire. not fun. Use stranded wire at times when the wire will be flexed repeatedly, and in higher current apps. you are going to have to plan out the chassis of your bot before you can figure out what kind / length / thread you need for the fasteners.
-
oh, i've built it myself.
-
If you look at the pics further in the tutorial it will be more obvious . . .
Its always good to have 22 or 24 gauge around when making robots, and of multiple colors.