Author Topic: external crystal fuse settings  (Read 3231 times)

0 Members and 1 Guest are viewing this topic.

Offline AdminTopic starter

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
external crystal fuse settings
« on: December 28, 2007, 02:57:31 PM »
I am using the ATmega2560 with a 16Mhz external xtal and want to set the correct fuse in AVR Studio.

I am assuming I must check the box that says 'Ext. Crystal Osc.:Frequency 8.0- MHz:Start-up time: 1K CK + 65ms' correct? I'd rather not guess, as it could kill my board . . .

(right now its using 8MHz internal resonator)

Also, what is the difference between 258 CK and 16K CK? Any good reasons to have a lower startup time?

Offline AdminTopic starter

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: external crystal fuse settings
« Reply #1 on: December 31, 2007, 08:15:02 AM »
Ok I set it to the Ext. Crystal Osc. with 16K CK and it works fine.

 


Get Your Ad Here