Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: silo_xtreme on February 16, 2008, 11:20:28 PM
-
Hi,
My JTAG says that my AREF is 0 Volts. How is that possible when I measured the pin at 4.5Volts ? I have AVCC = AREF connected to each other.
Any ideas?
-
The pin you measured is right off the chip, or somewhere on your board?
Does your ADC work otherwise?
-
The ADC is working. .. i think it's because the JTAG is looking to have that variable work for an STK500 ... at least that is what I heard on avrfreaks.