Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: Elias1001 on January 10, 2009, 07:19:13 PM
-
Hi, I just finished soldering the microcontroller, and I soldered in my battery pack. My question is: Should the servos start spinning immediately after they are plugged in? or are they only going to start spinning only after the programming steps?
-
They are going to spin after you program the microcontroller. Right now the microcontroller is blank, so it won't do anything.
-
+1 your servos will only spin once your microcontroller is programmed thus being able to send the signal to them