Society of Robots - Robot Forum
General Misc => Misc => Topic started by: ltmhall on November 13, 2006, 01:49:12 PM
-
Is there any way to increase the speed of two servo motors connected to a
Basic Stamp II? Or is the
PULSOUT 1, 850
PULSOUT2, 650
fastest they will turn.
-
Servos have their own speed limits, typically expressed as 60 deg/ X seconds of time. The lower X is, the faster the servo can go. Different types of servos have different speed maximums.
To command the servo to go as fast as possible, just keep increasing/decreasing the pulse until it makes no speed difference.
The applied load also affects speed, so lower loads will equate to higher speeds.
If you require faster, you will have to buy a faster servo . . .