ok, browsing around I found this:
http://www.ifas.htwk-leipzig.de/easytoweb/indexe.php?content=downloadAccording to
the manual, the software has "macros [that] allow the configuration of the data communication."
They have an example that shows me how to define which UART I want and baud rate using some form of GUI. Looks easy!
Just to make sure I understand this right, I upload the .hex bootloader using a programmer (MISO/MOSI stuff). Then to upload future programs, all I need to do is upload a different .hex using the UART, correct? Would I need to add anything to that second program, or can it run just as it was as if there wasnt a bootloader?
And I can use hyperterminal to upload the program while in bootload mode, right?
(only robotics can make me feel like a daily noob
)