Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: lemontree on December 01, 2009, 09:28:32 PM
-
One early lesson I learned was that if you remove the core from an AC solenoid for a few minutes it will burn out. That is because its inductance is lower with the core out and too much current flows through the coil. I wonder if anyone has done any practical work on using a solenoid as a position sensor?
If you apply a small amount of ac ripple to a dc solenoid you should be able to estimate the position of the core by measuring the ac current. By the time you had done all the electronics for that I doubt it would work out cheaper than a servo however.
-
Yes, I've played with this. There are commercial linear position sensors that use this principle and are called LVDTs. Here are some links:
http://www.rdpe.com/displacement/lvdt/lvdt-principles.htm (http://www.rdpe.com/displacement/lvdt/lvdt-principles.htm)
http://www.macrosensors.com/lvdt_macro_sensors/lvdt_products/index.html (http://www.macrosensors.com/lvdt_macro_sensors/lvdt_products/index.html)
-
Thanks for that. Have any interesting robots been made that exclusively use solenoids to move around? A project for myself would be to evolve a solenoid robot design. If ifs and ands were pots and pans.
-
I think I've seen a robot that used solenoids for movement on Utube.
It was lots of laughs but it worked.