Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: kronin on March 22, 2009, 09:31:49 AM

Title: modified $50 to include motorcontroller
Post by: kronin on March 22, 2009, 09:31:49 AM

hi, after reading a few topics on the subject, i decided to try and put together a schematics that included a dc motor controller. would anyone please check and see if this might work? i am using a connector from the mega8 to the motorcontroller, so that i can disconnect it, and use servos, if i happend to find any of those ;-)
don´t pay too much attention on component values, as im just looking for confirmation that this will work (or maybe not work, but then solutions would be appreciated)

Title: Re: modified $50 to include motorcontroller
Post by: Admin on March 25, 2009, 01:54:28 AM

Can you post us up a .png of it? (just use the export function in eagle)

This way we don't have to require eagle or be bothered to load it up.

Also, if you followed the datasheets correctly, it will work :P

Title: Re: modified $50 to include motorcontroller
Post by: kronin on March 27, 2009, 11:22:24 AM

Sorry for the late reply, but i´ve been busy
here´s the PNG.

Title: Re: modified $50 to include motorcontroller
Post by: superchiku on March 27, 2009, 12:19:43 PM

will work ..bu u have tochange the source code

Title: Re: modified $50 to include motorcontroller
Post by: kronin on March 27, 2009, 02:37:14 PM

Thanks  - fortunately, i know a C / C+ Wiz kid, so coding will not be the biggest problem, but he´s not at all into the electric/mechanical stuff so that´s the part where i´m going solo.
I wouldn´t continue with the dc controller, if any one of you told me that it wouldn´t work, but i take it as i can continue my work