Thanks for the response.
But the two rows of six don't have to be next to each other, right? Cause if they do then I think I can only connect them so they they are all 12 connected to each other. I'm really noob though so I'm not too sure.
also I'd like to ask if you need a DIP Socket when using a breadboard.
Ah and is it bad when the 2 5-Pin headers where the programmer needs to be connected are connected? Like in sets of 2? Because It's hard to make them in my bread board like they are in the schematic. =(
I'm trying to make the circuit in a breadboard but I keep getting difficulties like this. =(