Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: cooldog on February 02, 2008, 09:06:36 PM
-
what reistor is use to make the photocell sensor
http://www.societyofrobots.com/schematics_photoresistor.shtml
-
2 questions for you.
1- which resistors did admin order?
2- which one did he use for the led?
-
340ohm
1.62K
don't know which one he used for the LED
-
I think (70% sure) that I used the blue one. I can't check because it's covered in heatshrink. Wait for someone good to answer.
-
340 ohm for the led sounds right
i use a 10K ohm resistor on my photocells though
-
340ohm
1.62K
don't know which one he used for the LED
look at the picture, read teh tutorial. worst case senario use this to decode it http://www.dannyg.com/examples/res2/resistor.htm