Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: silo_xtreme on November 10, 2009, 04:57:07 PM
-
Hi Everyone,
What's a good way to debug a, RF TX and RX pair? I'm not sure if I have I have a problem on the TX or RX side and pointers would be great!
-
Not sure how to do it with out either a freq meter to tell if the TX is transmitting, or another TX/RX pair so you can swap out one piece at a time.
-
434 mhz transmitter should be picked up on any scanner. that's how you check out that end.
-
I didn't see that it was 434 MHz unless you're just throwing out that little useful bit of info.