Author Topic: lost in "50$ robot" limbo  (Read 1650 times)

0 Members and 1 Guest are viewing this topic.

Offline nortronTopic starter

  • Jr. Member
  • **
  • Posts: 7
  • Helpful? 0
lost in "50$ robot" limbo
« on: July 22, 2010, 06:08:26 PM »
hey guys, im making progress for the most part although im stuck on aligning servo's to 0.  I have avrisp2 programmer, i want to remove .hex file to re-install it but not sure which one it is , when i now click on the link it just comes up as non-coded jibberish.  any ideas?                                     


                                              thanks for reading

Offline SmAsH

  • Supreme Robot
  • *****
  • Posts: 3,959
  • Helpful? 75
  • SoR's Locale Electronics Nut.
Re: lost in "50$ robot" limbo
« Reply #1 on: July 23, 2010, 01:09:20 AM »
Can you right click the link and select "save target as"?
Howdy

Offline nortronTopic starter

  • Jr. Member
  • **
  • Posts: 7
  • Helpful? 0
Re: lost in "50$ robot" limbo
« Reply #2 on: July 23, 2010, 02:07:58 PM »
yeah, "save link as" gives me an icon.  I really dont think i installed it (if thats what your suppose to even do), everytime ive tried to open it gives jibberish..........




                                              thanks for reading

Offline Razor Concepts

  • Supreme Robot
  • *****
  • Posts: 1,856
  • Helpful? 53
    • RazorConcepts
Re: lost in "50$ robot" limbo
« Reply #3 on: July 23, 2010, 02:10:38 PM »
The hex file is just the data, to flash the code into the microcontroller (not really "install") you need to go through ponyprog (look deeper into the tutorial)

 


Get Your Ad Here