Author Topic: Eagle3D - soldermask stop not working?  (Read 1637 times)

0 Members and 1 Guest are viewing this topic.

Offline Razor ConceptsTopic starter

  • Supreme Robot
  • *****
  • Posts: 1,856
  • Helpful? 53
    • RazorConcepts
Eagle3D - soldermask stop not working?
« on: August 09, 2010, 10:28:58 AM »
I was just wondering if somebody who has experience with Eagle3D could help me. Does Eagle3D not render the soldermark stop?

I had a bare PCB, no copper anywhere, just soldermask and an area of soldermark stop (tstop layer). Upon rendering, I only get a dark green board, there is no "pcb" material in the area where I designated the tstop.

Is this just how eagle3d works since usually it is not important?

 


Get Your Ad Here

data_list