Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: Icewind007 on May 03, 2007, 09:53:09 PM

Title: H-Bridge with Two 2-way Motor control
Post by: Icewind007 on May 03, 2007, 09:53:09 PM
I am using the SN754410 QUADRUPLE HALF-H DRIVER.  It says it can be used with two 2 directional motors.  I am not very familiar with how to work with these but I managed to use an entire one of these H-bridges to get one motor going two directions.  Could I get any tips  or schematics on how to properly get this one h-bridge to run two motors in two directions?  The specs are at this website.


http://info.hobbyengineering.com/specs/SN754410.pdf (http://info.hobbyengineering.com/specs/SN754410.pdf)
Title: Re: H-Bridge with Two 2-way Motor control
Post by: JonHylands on May 03, 2007, 10:00:16 PM
Check out the schematic on my Seeker 2 page:

http://www.huv.com/miniSumo/seeker2/Schematic.gif

- Jon
Title: Re: H-Bridge with Two 2-way Motor control
Post by: ed1380 on May 08, 2007, 02:14:43 PM
Check out the schematic on my Seeker 2 page:

http://www.huv.com/miniSumo/seeker2/Schematic.gif

- Jon

that looks like a mixture of these 2  http://www.allegromicro.com/en/Products/Part_Numbers/2981/index.asp and http://www.allegromicro.com/en/Products/Part_Numbers/2559/index.asp

according to your link "K" on my second link could be "Rc2" and "Rc3"
Title: Re: H-Bridge with Two 2-way Motor control
Post by: JonHylands on May 08, 2007, 02:58:53 PM
Well, its not, its a single SN754410, which is why I pointed it out...

- Jon