Author Topic: how to use jump wires  (Read 2126 times)

0 Members and 1 Guest are viewing this topic.

Offline vader1110Topic starter

  • Jr. Member
  • **
  • Posts: 9
  • Helpful? 0
how to use jump wires
« on: September 25, 2008, 07:08:22 PM »
i know the Arduino has the same header as  a servo so do i use jump wires to connect them ??? please help!!!!!!!!!!
   

Offline Ro-Bot-X

  • Contest Winner
  • Supreme Robot
  • ****
  • Posts: 1,431
  • Helpful? 25
  • Store: RoBotXDesigns.ca
    • Ro-Bot-X Designs
Re: how to use jump wires
« Reply #1 on: September 25, 2008, 08:44:48 PM »
You have 3 options:

- buy or build a shield with ready made 3 pin headers for servos;
- buy or make jump wires (male to female);
- cut the servo wire and install single female headers on each wire.

If you look carefull in the comercial banner on the right of this screen, sometimes you will see one from Curious Inventor. They have those jump wires...
Check out the uBotino robot controller!

 


Get Your Ad Here

data_list