Author Topic: Few questions in circuit  (Read 2319 times)

0 Members and 1 Guest are viewing this topic.

Offline darkjungleTopic starter

  • Jr. Member
  • **
  • Posts: 11
  • Helpful? 0
Few questions in circuit
« on: August 23, 2007, 11:21:14 AM »
The data sheet of atmega 8 says that Avcc should be connected to vcc through a low pass filter,if adc pins are used.Is it necessary?How?
Should the reset pin be grounded through a switch?
Logged

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: Few questions in circuit
« Reply #1 on: August 25, 2007, 07:28:55 PM »
I had the same question back in February:
http://www.societyofrobots.com/robotforum/index.php?topic=606.0

Quote
Should the reset pin be grounded through a switch?
No, you need that pin for the programmer.

This is what I did:
http://www.societyofrobots.com/images/sbs_avr_schematic.png
Logged
 

data_list