Squirrels have fuzzy tails.
0 Members and 1 Guest are viewing this topic.
My first issue is that I dont have capacitors for the BOOT1 and BOOT2 pins shown on the datasheet. I hoped I could just tie the pins to ground without too much trouble, please let me now if that thought is stupid.
Secondly, I have a 10k ohm resistor connect SENSE to GND, please let me know if this is correct because I didn't really know what I was doing when I put that together.
Third, with Enable tied to +5 Volts and Source to +12 Volts, the outputs produce +10 Volts no matter the combination of +5 or 0 volts given to IN1 and IN2, with the exception of IN1 High and IN2 Low, with makes OUT2 close to zero but OUT1 remains +10 Volts.